How To Fix Bent Charger

| April 23, 2023 | Fix it | No Comments
Bent chargers are a common problem that we all face at some point. Whether it’s due to excessive use or accidental damage, a bent charger can be frustrating and inconvenient. However, the good news is that fixing a bent charger is relatively easy and can be done with a few simple steps. In this article, we will guide you on how to fix a bent charger.

Step 1: Turn Off Your Device

Before you start fixing your bent charger, it’s important to turn off your device. This is to avoid any electrical hazards while you work on the charger. Make sure that your device is completely turned off before proceeding.

Step 2: Unplug the Charger

Next, unplug the charger from the power source and your device. This is to ensure that you don’t get any electric shocks or short circuits while working on the bent charger.

Step 3: Inspect the Charger

Take a closer look at the charger and identify the location where it is bent. It could be at the end that connects to your device, or it could be in the middle of the cable. Once you identify the location, gently straighten the bent area with your fingers.

Step 4: Use a Plier

If the bend is too severe, you may need to use a plier to straighten the cable. However, be careful not to apply too much pressure, as this can damage the internal wiring of the charger.

Step 5: Test the Charger

After straightening the bent area, plug the charger back into the power source and your device. Turn on your device and check if the charger is working correctly. If it’s working fine, then your problem is solved.

Frequently Asked Questions (FAQs)

Q: Can I still use a bent charger?

A: It’s not recommended to use a bent charger as it can damage your device’s charging port and cause electrical hazards. It’s best to fix the charger as soon as possible.

Q: How do I prevent my charger from bending?

A: To prevent your charger from bending, avoid twisting or pulling it too hard. Also, make sure to store it properly when not in use.

Q: What if my charger is still not working after fixing it?

A: If your charger is still not working after fixing it, it’s best to replace it with a new one.

Conclusion

A bent charger can be a frustrating issue, but it’s not the end of the world. By following the steps mentioned above, you can easily fix a bent charger and get back to charging your device. Always remember to handle your charger with care to prevent future issues.